plex media server raspberry pi 3 hard drive

I followed the directions for from the article, doing the 'apt' update and full-upgrade, editing the file '/etc/defaults/rpi-eeprom-update' and performing the 'rpi-eeprom-update' followed by a reboot.Īfter the update, I checked the firmware with 'vcgencmd bootloader_version', but it reported the old firmware. The following are the steps I then followed: '/boot' was still mounted from the SD card in '/etc/fstab', but everything else was mounted from the external hard drive. It's much faster, and more spacious, than the SD card. I have been booting off of an SD card with my root file system on the external drive for months now with no problems. dev/sda8 ext4 (502.0 GiB) 'future' (not mounted)Note that this does not follow the SD card partitioning (at least for the 'Noobs' image) which appears to have 'Recovery' as the primary partition, and in the extended partition, a partitions for '/boot', a 'Settings' partition that doesn't seem to get mounted, and the root partition. In my case, I had partitioned the external drive (a 1TB Seagate 'Backup Plus Portable' USB 3.0) as follows: I have successfully done the firmware upgrade without messing up my USB external drive contents or configuration.

Special thanks to Jay Moulin who made this docker image, which helped me remove and update my long outdated PMS.: I am not an authority on this, but my answer is a qualified 'yes'. “ docker run -d –restart=always –name plex -v /mnt/usbdrive:/media –net=host jaymoulin/plex” Starting up PMS and configuring itĬonfigure your PMS, by opening “ It’s important to open it’s local IP address.

Pull the docker image and create the container: Pulling the image and creating a container Start docker back up “ sudo service docker start“. Make a symlink to the original place: “ ln -s /mnt/usbdrive/docker /var/lib/docker” Then move the “ /var/lib/docker” directory to your new partition: “ mv /var/lib/docker /mnt/usbdrive/docker“. If you haven’t mounted your external drive: “ sudo mount /dev/sda1 /mnt/usbdrive” Next, if you have low free storage space on your SD card, you can move most of docker’s files to your external drive.įirst of all stop docker, by running: “sudo service docker stop“. Note that it will also install python-pip.

Plex media server raspberry pi 3 hard drive